1

Disconnect the mobile phone enabled by the Bluetooth® system and remove from inside the vehicle.

If the mobile phone is not removed from the vehicle and a call is received during the installation process, the procedure will not be successful.

2

Insert the USB memory stick in the USB port of the diagnostic instrument.

Insert the update CD in the diagnostic equipment, then turn it on.

Select the language in which instructions are to be read.

When the final user licence appears, press I Accept

You cannot continue if you do not press I Accept

3

Select Create update memory stick in the main menu, wait for the software to install (Capacity update USB error or USB error 10 or not even the insufficient space error on the USB memory stick should not appear on the panel) on the USB memory stick and remove it.

The USB memory stick is not supported by the diagnosic instrument or sofware (or, in the event of an error, its capacity is insufficient): use a compatible USB memory stick with sufficient capacity.

Memory sticks supported are whose with standard USB 1.0, 1.1 or 2.0 and capacity up to 1 GB. The following models are definitely supported: Lexar(tm) JumpDrive(r) 2.0 512 MB, Memorex(r) Travel Driver 256 MB USB 2.0, Memorex(r) Travel Driver 1 GB USB 2.0, PNY(r) Attaché 256 MB USB 2.0, SanDisk(r) Cruzer(tm) micro 256 MB USB 2.0, SanDisk(r) Cruzer(tm) Mini 256 MB / 1 GB USB 2.0 e Sony(r) Micro Vault(r)

4

Turn the ignition key to the OFF position.

Insert the USB memory stick in the dedicated port in the centre console

Turn the ignition key to the ON position.

Check that the update starts and the words "USB memory stick not found" do not appear in the instrument panel.

The procedure will not be successful if the USB memory stick is removed during the installation procedure. Re-insert the memory stick, wait for 30 seconds and repeat this step.

Reinsert the USB memory stick correctly or use another USB memory stick.

5

After the update, check that the message "Update complete" appears on the instrument panel and not one of the errors "USB key error" or "Capacity/Signature/File USB update error or USB error10/20/30” (message depends on the vehicle specification).

The procedure will not be successful if the USB memory stick is removed during the installation procedure. Re-insert the memory stick, wait for 30 seconds and repeat this step.

If an error is present, try and return to Step 2.

If the problem persists, move on to Step 7

6

Turn the ignition key to the OFF position.

Remove the USB memory stick from the USB port.

The test can be considered over

7

The problem may be caused by a non-original update CD.

Ensure that a copy of the update CD has not been used to run the procedure

Replace the Bluetooth(r) control unit

   Op. 5570T49 BLUETOOTH ELECTRONIC CONTROL UNIT - R.R.