|
STEP |
CHECK TO BE PERFORMED |
REMEDIAL ACTION IF THE CHECK IS NOT OK |
|
1 |
-Check button for raising headlamp alignment Disconnect the left control panel - Turn the key on. - Bridge terminals 3-1 at the wiring connectors with a resistance of 180 Ohm and check operation. If Ok, replace the left control panel Op. 7040A82 SWITCH UNIT ON LEFT SIDE OF DASHBOARD - R.R. Connect the multimeter at terminals 3-1 of the panel: the reading should be 180+25 Ohm when the CAF Up button is operated |
Restore the correct wiring |
|
2 |
-Check button for lowering headlamp alignment Disconnect the left control panel - Turn the key on. - Bridge terminals 3-1 at the wiring connectors with a resistance of 910 Ohm and check operation. If Ok, replace the left control panel Op. 7040A82 SWITCH UNIT ON LEFT SIDE OF DASHBOARD - R.R. Connect the multimeter at terminals 3-1 of the panel: the reading should be 910 Ohm ±1% when the CAF Down button is operated |
Restore the correct wiring |
Left control panel connector
|
Connector pin out |
|
|
Pin |
Function |
|
1 |
Earth |
|
2 |
Lighting positive |
|
3 |
CAF Up-Down control |
|
4 |
MODE+ control |
|
5 |
Spare |
|
6 |
Spare |
|
7 |
FN-RFN control |
|
8 |
Spare |
|
9 |
Spare |
|
10 |
Spare |
|
11 |
Spare |
|
12 |
MODE- control |