|
There are two lights for lighting up the ground ("puddle lights") in the front front doors. The timing of lights is based on a logic managed by the Body Computer and they come on when the doors are opened, irrespective of the position of the ignition switch. The lights stay on for 3 minutes and go out when the door is closed. The power supply for all the courtesy lights follows the battery voltage control logic (SBMT): with the key off when any door or the boot is opened, a time of 15 seconds is set. After this, all the courtesy lights are deactivated. |
|
The Body Computer M001 receives "door open" input signals at pins 54 (driver's door) and 53 (passenger side door) of connector B of M001. The two (puddle) courtesy lights G051 and G052 are supplied, according to the logic described previously, by the line protected by fuse F032 located in the Body Computer M1. The Body Computer M001 - connector A - receives a direct powr supply from the battery through the line protected by maxi fuse F01 of the engine compartment junction unit B001. The Body Computer M001 receives an ignition-controlled power supply (INT) at pin 11 of connector E. Pin 9 of connector E of M001 provides the Body Computer with a reference earth. Body Computer M001 is connected via the CAN line to instrument panel E050, to which it sends a signal that turns on the door open warning light, where necessary, and activates the buzzer to give an acoustic signal. Lights G051 and G052 are supplied by the Body Computer M1, from pin 20 of connector C, whilst the timed analogue signal arrives from pin 7 of connector B. |
|
Diagram not captured
../955000073.image The original SVG asset is absent from this archive. The captured text and component links below remain available.
|
|
Diagram not captured
../955000074.image The original SVG asset is absent from this archive. The captured text and component links below remain available.
|