Contents

			Test results
1	COMPONENT CONCERNED	DOOR DETENT LINK ALIGNMENT CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Door check strap (body side)	Check that the door detent link is aligned correctly	Go to Step 2	Door detent link offset	Loosen the door detent link fastening (only body side). Carry out adjustments to realign the link with its correct operating axis, then tighten the fastenings to the prescribed torque again.
2	COMPONENT CONCERNED	DOOR DETENT LINK ALIGNMENT CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Door check strap (door side)	Check that the door detent link is aligned correctly	Go to Step 3	Door detent link offset	Loosen the door detent link fastening (only door side). Carry out adjustments to realign the link with its correct operating axis, then tighten the fastenings to the prescribed torque again.
3	COMPONENT CONCERNED	DOOR DETENT LINK OPERATION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Door detent link	Check that the door detent link is operating correctly	Go to Step 4	Door detent link hardened	Open the door of the vehicle as far as possible, clean the dirt from the rod of the link then grease the internal mechanism with BECHEM “Berulub palfluid” lubricating grease or MOLYKOTE “D96”. Carry out 20–30 complete door operations.
4	COMPONENT CONCERNED	DOOR DETENT LINK OPERATION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Door detent link	Check that the door detent link is operating correctly	Go to Step 5	Door detent link seized	If, after removing the door detent link from the car, sticking/stiffness is not detected when closing and opening the door, replace the link Op. 7005A28 FRONT SIDE DOOR LIMITER - R.R.
5	COMPONENT CONCERNED	DOOR HINGE POSITIONING CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Door hinges	Check that the hinge rotation axis is aligned correctly	End of diagnosis	Hinge rotation axis misalignment	Adjust the hinges until the door moves freely, without sticking. Reassemble the original link