Contents

			Test results
1	COMPONENT CONCERNED	FUSE CONDITION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Fuse	Check the condition of the cigar lighter fuse	Go to Step 2	Fuse damaged	Replace the fuse and try to determine the cause of the malfunction
2	COMPONENT CONCERNED	SLEEVE CONNECTIONS CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Power socket connections	Check that the connections between the cable loom connector and the power socket connector are correct	Go to Step 3	Connector has come out	Restore the correct connections
3	COMPONENT CONCERNED	SLEEVE SUPPLY CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Sleeve	Using a multimeter, connect the probes to the central rivet (+) and the sleeve flange (-) and check for the presence of a supply voltage of approximately 13.5. This test should be carried out with the battery charged and engine running.	Go to Step 4	Voltage value below 10 V (measured with car in motion). No continuity	Check electrical system Replace the sleeve Op. 7065C72 FRONT CIGAR LIGHTER SOCKET - R.R.
4	COMPONENT CONCERNED	SLEEVE CONDITION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Sleeve	Check for the absence of contamination by fluids or other substances or oxidation inside the sleeve	Go to Step 5	Sleeve oxidised	Replace the sleeve Op. 7065C72
5	COMPONENT CONCERNED	SLEEVE CONDITION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Sleeve	Check for the absence of mechanical deformation in the sleeve	Go to Step 6	Presence of mechanical deformation in the sleeve (e.g. excessive ovality)	Replace the sleeve Op. 7065C72
6	COMPONENT CONCERNED	POWER SOCKET CLEANLINESS CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Power socket	Check for foreign bodies inside the sleeve	Go to Step 7	Foreign bodies present	Remove the foreign bodies and restore correct operation
7	COMPONENT CONCERNED	SLEEVE CONDITION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Sleeve	Check for the absence of contamination by fluids or other substances or oxidation inside the sleeve	Go to Step 8	Sleeve oxidised	Replace the sleeve Op. 7065C72
8	COMPONENT CONCERNED	RING NUT CONDITION CHECK	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Ring nut	Using special pliers, remove the sleeve from the ring nut and check that there are no breaks or deformation	Go to Step 9	Presence of breaks or deformation	Replace the plastic fitting ring nut
9	COMPONENT CONCERNED	CORRECT ILLUMINATED RING NUT SUPPLY CHECK (only on cars where present)	OK (NO FAULTS DETECTED)	FAULT DETECTED	OPERATION
	Ring nut	Check for a supply voltage of approximately 13.5. This test should be carried out with the battery charged and car in motion.	End of diagnosis	No supply Fitting ring nut not illuminated	Restore the correct power supply Replace the ring nut