| NAVIGATOR - DESCRIPTION | NAVIGATOR - FUNCTIONAL DESCRIPTION | NAVIGATOR - WIRING DIAGRAM | NAVIGATOR - COMPONENT LOCATION | Print electrical function |
DESCRIPTIONThe Blue&Me system, alongside the Bluetooth technology for using a mobile phone in the vehicle, is also available with a navigation system for reaching a destination speedily and safely. The driver is guided to the destination by voice messages and instructions in the instrument panel display. The navigator makes it possible to: - enter a new destination - navigate to a point of interest (which can be selected from a list of categories such as, for example, hotels, restaurants, airports, railway stations, etc.) - acquire journey information (arrival time, distance from the destination, vehicle position) - recover the last destinations memorised - set preferences for the type of route to be followed such as, for example, motorway, toll roads, - simulate the route to a prearranged destination in advance. The GPS consists of an aerial that allows the vehicle to be GPS satellite-located: the aerial is connected to a receiver located in the integrated unit by means of a special shielded cable. The GSM aerial is connected to the GSM unit inside the control unit used for the connection of GPRS data for services such as traffic in real time, navigation, etc. The stylus aerial is fitted at the rear of the roof: it performs three functions (radio/GSM/GPS) because it also incorporates the radio aerial. Vehicle position is identified by analysing GPS data together with speedometer and reverse gear signals received from the vehicle. The navigation maps are loaded onto the USB device connected to the USB port on the vehicle. The control unit that manages the entire system is a CAN node via which information is exchanged with the Body Computer, the instrument panel and the other electronic units (e.g. the navigation system downloads information from the odometer, reverse engagement signal etc.). ). The control unit is then connected to the radio controls on the steering wheel (in addition to the radio control buttons, there are 2 specific buttons for this function). The entire operation of the system is also managed by voice commands, received by the microphone near the front roof light. There are three additional control buttons in the panel in front of the centre roof light: - NAV: launch of the Navigation Menu - display of incoming information with navigation activated - SOS: access to Roadside Assistance Services - Info: access to infomobility services For more details on the operation of the system |