Check that the labyrinth seal cap is present and correctly fastened on the cover
Go to Step 2
Labyrinth seal cap partly detached:
- Labyrinth seal cap fitted OK (FIG. 1)
- Labyrinth seal cap fitted not OK (FIG. 2)
Remove the cap and refit it correctly
2
COMPONENT CONCERNED
COVER FASTENING CHECK
OK (NO FAULTS DETECTED)
FAULT DETECTED
OPERATION
ELLIPTICAL FN
(Black/chrome frame)
Check that the cover is correctly fastened
Go to Step 3
Cover is not correctly screwed on:
- Cover fastened OK (FIG. 3)
- Cover fastened not OK (FIG. 4)
Remove the cover (in the same way as for replacing a burnt-out lamp) and screw it on again, closing it correctly
3
COMPONENT CONCERNED
SEAL CHECK WITH IMMERSION
OK (NO FAULTS DETECTED)
FAULT DETECTED
OPERATION
ELLIPTICAL FN
(Black/chrome frame)
Check seal by immersing the device in water, supplying air from the connector seat at a pressure of 40 mbar, removing the labyrinth seal cap and plugging the seat with a ball of modelling clay, see (FIG. 5)
No air bubbles can be seen coming out of the fog lamp.
