|
- Open the intermediate retaining clips for vacuum pipe from chamber to the LPG pressure regulator.
|
|
|
 Refitting
(
Removing
)
- Place the vacuum pipe from the chamber to the LPG pressure regulator in its housing and tighten the bands, on LPG pressure regulator side.  | Maintain a distance of 3 - 5 mm between the bands and the ends of the pipe. |
|
|
|
- Connect to the chamber the vacuum pipe from the chamber to LPG pressure regulator and close the clip.
|
|
Keep a distance of 3 - 5 mm between the clip and the end of the pipe.
|
- Engage the intermediate retaining clips for vacuum pipe to chamber to the LPG pressure regulator.
- Fit the engine cooling supply reservoir in place and secure it using the screws.
|
APPLIES TO VERSIONS WITH: Euro 5
APPLIES TO VERSIONS WITH: Euro 5
|
1. Open the band and disconnect the vacuum pipe from chamber to LPG pressure regulator, chamber side.
2. Open the retaining clip for the vacuum pipe from chamber to the LPG pressure regulator.
|
|
APPLIES TO VERSIONS WITH: Euro 5
APPLIES TO VERSIONS WITH: Euro 5
APPLIES TO VERSIONS WITH: Euro 5
APPLIES TO VERSIONS WITH: Euro 5
|
|
Refitting
(
Removing
)
- Place the vacuum pipe from the intake chamber to the LPG pressure regulator in position and tighten the bands. | Maintain a distance of 3 - 5 mm between the band and the end of the pipe. |
- Close the retaining clips for the vacuum pipe from chamber to LPG pressure regulator. - Place the cooling circuit inlet/outlet pipes from the LPG pressure regulator in their housings and close the retaining clip. |
|
APPLIES TO VERSIONS WITH: Euro 5
APPLIES TO VERSIONS WITH: Euro 6
APPLIES TO VERSIONS WITH: Euro 6
|
1. Open the band and disconnect the vacuum pipe from chamber to LPG pressure regulator, chamber side.
2. Open the retaining clip for the vacuum pipe from chamber to the LPG pressure regulator.
|
|
APPLIES TO VERSIONS WITH: Euro 6
APPLIES TO VERSIONS WITH: Euro 6
APPLIES TO VERSIONS WITH: Euro 6
APPLIES TO VERSIONS WITH: Euro 6
|
|
Refitting
(
Removing
)
- Place the vacuum pipe from the intake chamber to the LPG pressure regulator in position and tighten the bands. | Maintain a distance of 3 - 5 mm between the band and the end of the pipe. |
- Close the retaining clips for the vacuum pipe from chamber to LPG pressure regulator. - Place the cooling circuit inlet/outlet pipes from the LPG pressure regulator in their housings and close the retaining clip. |
|
APPLIES TO VERSIONS WITH: Euro 6
