		Test results
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the diagnostic equipment to the body computer node and check, in the parameters mode, that the boot lid status (open or closed) is correctly received.	Move on to Step 4	The status of the boot lid is not received.	Move on to Step 2
2	ELECTRICAL CIRCUIT CHECK	All OK	Problems encountered	Operation
	Check that the electrical connection between the boot lid switch and the body computer node is insulated and not interrupted.	Move on to Step 3	Electrical connection interrupted or not insulated.	Restore the continuity/insulation of the electrical connection between the boot lid switch and the Body Computer node. See See E7015 ALARM
3	COMPONENT OPERATION CHECK	All OK	Problems encountered	Operation
	Disconnect the connector, body computer node side, and check for the presence of the boot lid open/closed signal. See See E7015 ALARM	Move on to Step 4	Boot lid electric switch not working.	Replace the boot lid lock See E7015 ALARM
4	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Replace the body computer node Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R. Search for the fault starting from another symptom

One second after the boot lid opening command (from the remote control), the system is automatically reactivated if it does not detect the opening of the boot lid, switching on the volumetric, anti-tilt and perimeter protection.

With the alarm on, after a boot lid opening/closing cycle, the system no longer switches on.