TEST RESULTS

Connect the Examiner equipment to the diagnostic socket and check at the body computer node in the alarm memory for:

· Possible presence of errors

Move on to Step 2

1. Volumetric protection activated

2. Anti-tilt protection activated

3. Presence of errors

1. Move on to Step 2

2. Move on to Step 3

3. Proceed as instructed by the diagnostic equipment

Check that no insect has entered the passenger compartment that could have moved around to set off the alarm or any moving object that may have been detected by the ultrasound sensors.

Check that the vehicle windows are properly shut, especially if there are strong winds.

Move on to Step 3

1. Insect in the passenger compartment that is detected by the ultrasound sensors when it moves around.

2. Vehicle windows open when there are strong winds.

1. Remove the cause of the alarm activation.

2. Close the car windows.

Connect the Examiner diagnostic equipment to the diagnostic socket and check the body computer node in active diagnosis mode to ensure that the ultrasound and anti-tilt sensors are working properly.

Connect the Examiner diagnostic equipment to the diagnostic socket and check the body computer node in active diagnosis mode to ensure correct operation

Move on to Step 4

1. Anti-tilt sensor faulty

2. Ultrasound faulty

1. Replace the anti-tilt and ultrasound sensors module

2. Replace the anti-tilt and ultrasound sensors module

Connect the Examiner diagnostic equipment to the diagnostic socket and check at the body computer node that the microswitches for the doors, bonnet and boot are working properly. In particular, check that there are no problems when the doors are closed

Move on to Step 5

Peripheral microswitch faulty

Replace the faulty lock.

Connect the Examiner diagnostic equipment to the diagnostic socket and check the condition of the A-Bus serial line between the Body Computer Node and the siren at the Body Computer Node in active diagnosis

 See Test 5580EB SIREN OPERATION CHECK

Move on to Step 6

Fault at A-BUS serial line

Restore the A-BUS serial line to correct operation

 See E7015 ALARM

Check that the siren power supply is correct and check the condition of the connections

 See Test 5580EB SIREN OPERATION CHECK

End of diagnosis

1. Power supply for the siren not correct due to a drop in voltage in the wiring

2. Vehicle battery run down (voltage below 8 Volts)

3. Body Computer defective

1. Restore the correct power supply

 See E7015 ALARM

2. Recharge the battery

3. Replace the body computer

 Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.