Refitting

   Op. 7040H80 REAR PARCEL SHELF - R.R.

1. Unscrew the bolts.

2. Move the rear side trim (2a) releasing the inner retainers (2b) using the special tool.

- Lower the side trim without disconnecting it from the rear seat belt.

1. Release the door housing seal in the area of the centre pillar cover.

2. Release the lower inner retainers (2a) for the cover (2b) using the special tool.

3. Release the upper inner retainers (3a) and detach the trim (2b).

4. Lower the trim (2b) without releasing it from the seat belt (4a).

1. Release the door housing seal in the area of the side panel.

2. Unscrew the bolt.

1. Unscrew the bolts.

2. Move the upper part (2a) of the side panel, releasing the inner retainers (2b) using the special tool.

1. Move the front upper section (1a) of the side panel slightly.

2. Extract the tweeter (2a) releasing the three perimeter retainers (2b).

3. Detach the electrical connection.

4. Keep the tweeter.

1. If necessary, extract the tweeter (1a) from the adaptor (1b) releasing the retainers (1c).

Removing

- Check that the tweeter is not damaged.

- If removed, fit the tweeter in the adaptor and attach the retainers.

- Connect the electrical connection for the tweeter.

- Place the tweeter in position and attach the perimeter retainers.

- Position the side panel and attach the inner retainers.

- Tighten the upper bolts securing the side panel.

- Lift up the centre pillar cover and position it attaching the retainers.

- Fit the door housing seal.

- Lift up and position the rear side trim and engage the retainers.

- Screw in the bolts.

   Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.