Test results
1
MOVEMENT OF LOWER FASTENINGS CHECK
All OK
Problems encountered
Operation
Check that the lower backrest fastenings on the vehicle move freely (rapid attachment to wheel arch)
Move on to Step 2
Interference from foreign objects or fastening elements
Remove the causes of the interference
2
MATCHING BETWEEN BACKREST AND VEHICLE INTERIOR TRIM CHECK
Check the matching of the backrest with the vehicle interior trim (wheel arch liners, door panels, etc.) folding the backrest over
Move on to Step 3
Interference from trims
Reposition the trims and/or carry out the correct backrest fitting cycle
3
CENTRE BRACKET CONDITION CHECK
Check the condition of the centre bracket (for the split seat). Also check there is no knocking
Move on to Step 4
No plastic bush on the rotation pin
Remove the backrest and fit the plastic noise prevention bush
4
CENTRE BRACKET CORRECT FASTENING CHECK
Check that the fastening of the centre bracket with the backrest structure and with the floor is correct
Move on to Step 5
Incorrect fastening of bracket with backrest and/or with floor
Retighten the bolts securing the centre bracket to the backrest and/or the floor to the correct torque
5
CORRECT OPERATION CHECK
Check that the fault is no longer present
End of diagnosis
The fault persists
Replace the left backrest
Op. 7050A13 SPLIT REAR SEAT LEFT BACKREST - R.R.
Replace the right backrest
Op. 7050A15 SPLIT REAR SEAT RIGHT BACKREST - R.R.
Hardening/creaking of backrest when folding over
