Test results

Check for interference in the correct sliding of the release lever in its trim

Move on to Step 2

Interference of the release lever with the cover/upholstery during operation, the lever does not return to the rest position

Remove the plastic parts eliminating the interference (excess fabric/upholstery)

Check that the alignment between the release unit and the slot in the plastic trim is correct

Move on to Step 3

Lever distorted, interference with plastic trim

Reposition the lever aligning it with the slot in the trim

After partly removing the upholstery in the lower part of the backrest, check the rivetting of the pin on the control lever and its condition (left and right sides)

Move on to Step 4

Excessive rivetting, pin locked, control lever broken

Replace the backrest assembly

 Op. 7045A18 FRONT SEAT BACKREST ASSEMBLY (ONE), LEFT OR RIGHT - R.R.

Check for weld residues, dirt on the backrest adjuster third plate

Move on to Step 5

Presence of foreign bodies, weld residues

Clean removing the weld residues or other causes of interference

Check the following, in order:

- the correct layout of the bowden control cable;

- the correct attachment of the outer casing retaining clip on the backrest;

- the condition of the release device in the upper area

End of diagnosis

1. Layout not correct

2. Outer casing retaining clip not correctly attached/released at the backrest

3. Release device in upper area broken/damaged (release lever)

1. Renew the correct routing of the control cables/outer casings

2. Refit the clip in the backrest frame

3. Replace the assembly

 Op. 7045A88 FRONT SEAT BACKREST FOLDING DEVICE WITH FLEXIBLE CABLES, LEFT OR RIGHT - R.R.