		TEST RESULTS
1	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect to the Bluetooth node using the Examiner and select Configurations in Active Diagnosis Carry out the Audio system test and check whether the radio emits a beeping noise	Move on to Step 2	There is no beeping noise emitted by the radio	Move on to Step 3
2	MICROPHONE CONNECTIONS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the continuity and the insulation of the electrical circuit between the microphone and the Bluetooth control unit See E4090 NAVIGATOR Check that the microphone is working properly	Move on to Step 3	1. Microphone not correctly connected. 2. Wiring between microphone and Bluetooth interrupted 3. Microphone defective	1. Restore the correct connection 2. Restore wiring continuity 3. Replace the control panel complete with microphone Op. 5580M20
3	WIRING CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the continuity of the connections between the Bluetooth and the radio Check that the power supply for the Bluetooth is correct See E4090 NAVIGATOR Check that the radio is correctly supplied See E3510 RADIO	End of diagnosis	1. Wiring interrupted 2. Bluetooth power supply not correct 3. Radio power supply not correct 4. Bluetooth defective	1. Restore the continuity of the connections between the Bluetooth node and the radio See E4090 NAVIGATOR 2. Restore the correct power supply for the Bluetooth 3. Restore the correct power supply for the radio. 4. If no faults have been found during the previous checks, replace the Bluetooth node Op. 5570T49 BLUETOOTH ELECTRONIC CONTROL UNIT - R.R.

The voice commands function is managed by the telephone module which is incorporated in the Bluetooth. Whilst the microphone is located outside on the control panel