Contents

		Test results
1	ERROR CHECK	All OK	Problems encountered	Operation
	Check for the presence of one or more of the following errors using the Examiner in Instrument Panel Node mode: - CAN line - EEPROM memory	Move on to Step 2	1. "No additional information" and/or "BUS off" detected 2. Fault in EEPROM memory	1. Continue as instructed by the diagnostic equipment 2. Replace the instrument panel
2	ACTIVE DIAGNOSIS CHECK	All OK	Problems encountered	Operation
	Use the Examiner to check the Autotest function is correctly activated in Active Diagnosis mode	Move on to Step 3	The function in question is not controlled by Active Diagnosis	Replace the instrument panel Op. 5560B10 CONTROL PANEL - R+R
3	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Contact the Service Department for further information on the problem