		Test results
0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
	Connect an EXAMINER and check the following at CAN INFORMATION: - No control units inactive - No faulty control units - No control units with faulty CAN	Move on to Step 1	1. Error at CAN 2. Communication with the Body Computer impossible	1. Continue following the instructions given by the diagnostic equipment 2. Move on to Step 5
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using the Examiner in the Instrument Panel Node mode, check that there are no errors and that the parameters are present	Move on to Step 4	1. Errors present 2. Communication with the instrument panel impossible	1. Continue following the instructions on the diagnostic instrument 2. Move on to Step 2
2	ELECTRICAL POWER SUPPLY CHECK	All OK	Problems encountered	Operation
	Check the electricity supply to the Instrument Panel Node is correct See E4010 INSTRUMENT PANEL	Move on to Step 3	Fault in positive electrical power supply and/or earth	Replace the defective component (in the case of a fuse, find out what caused it to blow)
3	ELECTRICAL CONNECTIONS CHECK	All OK	Problems encountered	Operation
	Check the electrical connections between the Body Computer and Instrument Panel, in particular, check that each individual pin is properly connected.	Move on to Step 4	Electrical connections not working	Restore the damaged electrical connections
4	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using an Examiner check, in Body Computer Node mode, that there are no errors	Move on to Step 7	1. Impossible to connect to the Body Computer control unit 2. Errors present	1. Move on to Step 5 2. Continue following the instructions on the diagnostic instrument
5	ELECTRICAL POWER SUPPLY CHECK	All OK	Problems encountered	Operation
	Check the Body Computer power supply is correct	Move on to Step 6	Fault in positive electrical power supply and/or earth	Replace the defective component (in the case of a fuse, find out what caused it to blow)
6	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Use an Examiner to check the possibility of connection to the Body Computer Node	Move on to Step 7	Impossible to connect to the Body Computer control unit	Replace the Body Computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.
7	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R

With the ignition ON, some of the warning lights are not timed and the instruments are not working with the engine running.