Contents

		Test results
0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
	Check that the fuel level gauge is not in the rest position.	Move on to Step 1	Fuel level gauge in rest position.	Move on to Step 2
1	ELECTRICAL CIRCUIT CHECK	All OK	Problems encountered	Operation
	Check the continuity of the cable between the fuel level sensor and the Body Computer See E4010 INSTRUMENT PANEL	Move on to Step 2	Cables interrupted	Restore the correct continuity for the cable See E4010 INSTRUMENT PANEL
2	FUEL LEVEL SENSOR CHECK	All OK	Problems encountered	Operation
	Check that the fuel level sensor is working properly	Move on to Step 3	Fuel level sensor not working.	Replace the fuel level sensor.
3	CAN NODES CHECK	All OK	Problems encountered	Operation
	Check that the Body Computer and/or Instrument Panel are correctly connected to the CAN	Move on to Step 4	Body Computer disconnected	Restore the correct connections See E8010 DIAGNOSTIC MULTIPLE CONNECTOR
		Move on to Step 4	Instrument Panel disconnected	Restore the correct connections See E4010 INSTRUMENT PANEL
4	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the Examiner diagnostic equipment and carry out Active Diagnosis on the fuel reserve warning light.	Move on to Step 5	The warning light is not working.	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
5	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the fault is no longer present.	End of diagnosis	Body Computer defective	Replace the Body Computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.