		Test results
0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
	Check that both the doors are properly shut	Move on to Step 1	Doors not properly shut	Shut the doors properly
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using the Examiner in the Instrument Panel Node mode, check that there are no errors and that the parameters are present	Move on to Step 2	1. Impossible to connect with the Instrument Panel control unit 2. Errors present	1. Move on to Step 2 2. Continue following the instructions on the diagnostic instrument
2	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using the Examiner check, in the Body Computer Node ambient, that there are no errors and that the door status parameters vary	Move on to Step 4	The parameters do not change	Move on to Step 3
3	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	- Check that the door switches in the geared motors are working properly - Check the insulation to earth of the connection between the door switches and the Body Computer See E3040 CENTRAL LOCKING	Move on to Step 4	1. Switches defective 2. Wiring with imperfect insulation to earth	1. Replace the switches 2. Restore wiring insulation
4	ACTIVE DIAGNOSIS CHECK	All OK	Problems encountered	Operation
	With the Examiner in the Instrument Panel Node ambient check that the doors open check warning light is correctly activated in Active Diagnosis	Move on to Step 5	The doors open check warning light is not activated	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
5	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Replace the Body Computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.

After having carried out the initial test, the doors open check warning light in the "Instrument Panel Node" remains on constantly