If a new module is installed, remove the detachable part of the adhesive label (if any) from the new module and place it in the special folder containing the vehicle details (model, registration date, chassis number) and the serial number of the old module. The folder must be kept for any checks necessary.

- Connect the electrical connection.

- Position the airbag module and attach the retainers.

1. Tighten the screws (1a) fixing the airbag module (1b).

Component	Fixing	dia	Value (daNm)	Validity
Knee Bag module	Screw	M6	0.6 ÷ 1.0

Op. 7040A37 FUSE BOX COVER IN INSTRUMENT PANEL - R.R

- Connect the battery.

- Use an Examiner to check that the system has not acquired errors during the operation.

APPLIES TO VERSIONS WITH: Right-hand drive

Removing ( Refitting

)

Before removing and refitting the airbag module the following preliminary operations must be carried out

- Turn the ignition key to “STOP” and extract it;

- Disconnect the battery cables and insulate them.

- Wait for 10 seconds before continuing.

FOLLOW ALL THE PRESCRIBED SAFETY INSTRUCTIONS (5580C - Introduction).

Op. 5580C AIR BAG SYSTEM

Op. 7040A45 RIGHT DASHBOARD SIDE TRIM - R.R.

APPLIES TO VERSIONS WITH: Right-hand drive

1. Undo the screws (1a) fixing the airbag module (1b).

APPLIES TO VERSIONS WITH: Right-hand drive

1. Move the airbag module (1a) slightly, releasing the retainers (1b) and (1c).

2. Disconnect the electrical connection for the airbag module.

	Name	Connector
1	DRIVER'S SIDE KNEE BAG	See Q014 DRIVER'S SIDE KNEE BAG

3. Keep the airbag module.

APPLIES TO VERSIONS WITH: Right-hand drive

- Place the airbag module in the special cupboard, resting it on a free surface with the bag facing upwards.

APPLIES TO VERSIONS WITH: Right-hand drive

Refitting ( Removing

)

- Observe the following precaution.

Handle the airbag module very carefully. Make sure that the battery is disconnected.

- Connect the electrical connection.

- Position the airbag module and attach the retainers.

APPLIES TO VERSIONS WITH: Right-hand drive

1. Tighten the screws (1a) fixing the airbag module (1b).

Component	Fixing	dia	Value (daNm)	Validity
Knee Bag module	Screw	M6	0.6 ÷ 1.0

APPLIES TO VERSIONS WITH: Right-hand drive

Op. 7040A45 RIGHT DASHBOARD SIDE TRIM - R.R.

- Connect the battery.

- Use an Examiner to check that the system has not acquired errors during the operation.