- Check the tyre tread is not worn.

Some types of tyre are fitted with wear gauges; they should be replaced as soon as these gauges are visible on the tread.

- Do not swap tyres across. - Check the tyre inflation pressure is correct, spare wheel included.

The tyre pressures must be checked when they are cold.

- Check that the lighting system is working properly: headlights, direction indicators, hazard warning lights, luggage compartment light, passenger compartment light and instrument panel warnings lights.

- Check that the windscreen washer/wiper system is operating correctly and adjust the nozzles if necessary.

- Check condition and wear of the front/rear disc brake pads and operation of pad wear indicator.

- Carry out a visual inspection of: exterior bodywork, underbody protection, pipes and hoses (exhaust - fuel system - braking system), rubber elements (boots - hoses - bushes - etc.).

- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage.

- Check and if necessary top up coolant level; refer to

    Op. 0010T21 ENGINE COOLANT - CHECK DENSITY AND TOP UP LEVEL IF NECESSARY

- Check and if necessary top up battery, washer fluid level, etc.

- Check and, if necessary, adjust the handbrake lever travel; refer to

    Op. 3380A04 HANDBRAKE - ADJUST TRAVEL

- Check exhaust emissions; refer to

    Op. 1080A10 IDLING C.O. LEVEL - CHECK WITH SPECIAL EQUIPMENT

- Check the operation of the engine management control systems (using the diagnosis socket).

- Replace the spark plugs; refer to

    Op. 5510D10 SPARK PLUGS - R+R

The following are vital in order to ensure correct operation and prevent serious damage to the engine: - only use spark plugs specifically certified for T-Jet engines which must be the same type and recommended make; - strictly comply with the spark plug replacement intervals detailed in the Scheduled Servicing Plan (every 30,000 km).

- Change engine oil and oil filter (or every 24 months); refer to

    Op. 0010T12 ENGINE OIL AND FILTER - REPLACE

If the vehicle is mainly used for town driving or has an annual mileage of less than 10,000 km, the engine oil and filter should be changed every 12 months.

- For EURO 6 versions only, replace the air cleaner cartridge; refer to

    Op. 1048A14 AIR FILTER FILTER ELEMENT - REPLACE

- Change brake fluid (or every 24 months).

    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY

    Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR

- Visually check LPG pipes and connectors, LPG tank fastening.

- Replace the paper filter, refer to

    Op. 1057B60 LPG FILTER - R.R.

- Check operation and parameters of the fuel system using the self-diagnosis socket.

- Replace the pollen filter (or every 24 months); refer to

    Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R.

- Check and print the battery charge conditions, using the special Midtronics FGA equipment, with possible battery recharging

At the end of the service, connect the Examiner diagnosis equipment to the on board diagnosis socket to zero the mileage counter for the days to the starting value and write the details of the service that has been carried out (date, service no., total mileage) in the Trip Computer memory which can only be read using the diagnosis equipment.

Check that the figure has been set in the instrument panel in km or miles depending on the unit of measurement in that country.