Disconnect the battery negative cable.

Connect the pressure transducer for the diagnostic equipment between the supply pipe (1) and the fuel filter inlet connector (2) using pipe N° 1870885001 (1) (Connector pipes) and pipe N° 2000024501 from case N° 2000024500 used with Kit EX 07 contained in case N° 1806338000.

Connect the negative battery lead.

Move the ignition key to MAR position and, within 3 seconds, make sure that the pressure shown on the pressure gauge is about 3.5 bar.

Start the engine, let it warm up and check that the pressure is about 3 bar.

The fuel pump in the tank should switch off after a few seconds.