|
The handbrake should only be adjusted after the rear brake pads or complete cables have been replaced. This is because the play take-up caused by wear is automatic. |
|
|
|
|
|
- Position the vehicle on a lift. |
|
|
|
  |
1. Mark the position of the adjustment nut and then back off by at least 2 or 3 turns to fully slacken the cables. |
|
|
- Start up the engine and operate the brake pedal energetically at least ten times. - Place the handbrake lever in the fifth notch on the toothed sector. - Tighten the adjustment nut on the handbrake lever until the rear wheels are not braked. - Check that the rear wheels are free to turn with the lever in the rest position. - Switch off the engine. |
|
|
|
|
|
- Remove the vehicle from the lift. |