Removing
(
Refitting
)
 | This procedure is valid only for the 120 HP version. |
|
|
Removing
(
Refitting
)
|
|
|
- Position the vehicle on a lift. |
|
|
  |
1. Disconnect the electrical connection for the front brake pad wear sensor and release the relevant wiring.
|
  |
1. Undo the screws (1a) and remove the front brake caliper (1b). |
  |
Refitting
(
Removing
)
1. Place the front brake caliper (1a) in its seat and tighten the new screws (1b) to the prescribed torque following the tightening order (tighten to a pre-torque of 1.5 daNm and then tighten to torque starting with the top screw).
|
|
|
- Connect the electrical connection for the front brake pad wear sensor and engage the relevant wiring. |
|
|
|
|
|
- Remove the vehicle from the lift. |
|
|
Removing
(
Refitting
)
|
|
|
|
|
|
- Place the vehicle on a lift. |
|
|
|
|
  |
1. Disconnect the electrical connection for the brake pad wear cable.
2. Undo the screws (2a) and remove the brake caliper (2b) with bracket. |
|
|
- If necessary remove the brake pads with reference to |
|
  |
Refitting
(
Removing
)
1. Place the brake caliper with bracket (1a) in position and tighten the screws (1b) to the prescribed torque.
2. Connect the electrical connection for the brake pad wear cable.
|
|
|
|
|
|
|
- Remove the vehicle from the lift. |