Refitting

1. Apply a double layer of bodywork adhesive tape (1a) around the outside of the initials (1b).

The adhesive tape will both protect the tailgate when the initials are removed and act as a template for applying the new initials.

2. Remove the initials (1b) releasing the adhesive bonding it to the tailgate using the special tool.

If necessary, gently heat the initials and the surrounding sheet using an air heater to make it easier to detach the adhesive.

Removing

- Check that the new logo is not damaged.

1. Leave the adhesive tape applied during removal for subsequent positioning of the initials.

2. If the initials (2a) were not present (and have not therefore been removed), refer to the positioning shown in the figure. The measurements indicated are in mm.

3. Clean and thoroughly degrease the area of the tailgate involved in the bonding of the initials using heptane.

4. Remove the film protecting the adhesive surface of the new initials, then immediately position the initials on the tailgate. Make the adhesive surface stick, applying manual pressure on the initials.

Do not touch the adhesive surfaces by hand during installation. Bond at an environmental temperature that is not excessively low.

5. Remove the adhesive tape used to position the logo.

- Apply pressure on the initials again to guarantee that the air bubbles are completely removed so that the adhesive adheres correctly to the surface of the tailgate.