|
|
|
|
|
Op. 7040H66 LEFT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R. |
|
Op. 7040H67 RIGHT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R. |
|
- Work on both sides. Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R |
|
|
|
|
|
- Remove all the handles. Op. 7065C28 GRAB HANDLE ON ROOF LINING (ONE), LH OR RH - R.R. |
|
|
Op. 7040H16 ROOF PANEL LINING FOR VERSIONS WITH SUN ROOF - R.R |
|
|
  |
1. Bring the guides (1a) manually to the rear end of travel position. |
  |
1. With the guide in the previous rear end of travel position, place the sliding roof movement motor (1a) in position and engage its pinion (1b) with the drive cables (1c), making sure not to move the drive cables, to align the sliding roof guides correctly. |
  |
1. Tighten the bolts fixing the motor. 2. Connect the electrical connection.
|
|
|
- Refit the clear section of the sliding roof. |
|
- Provisionally connect the sun roof control switches and check that the sliding transparent panel slides and closes correctly. Op. 7040H16 ROOF PANEL LINING FOR VERSIONS WITH SUN ROOF - R.R |
|
|
Op. 7065C28 GRAB HANDLE ON ROOF LINING (ONE), LH OR RH - R.R. |
|
|
|
|
|
Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R |
|
Op. 7040H67 RIGHT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R. |
|
Op. 7040H66 LEFT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R. |
|
|
|
  |
After the battery has been disconnected or a fuse has blown or the motor has been removed, the operation of the sliding roof must be initialised again. Proceed as follows: - press the closing button (A) until the roof is completely closed. - release the button. - press the closing button (A) and keep it pressed for at least 10 seconds and/or until the glass panel clicks forwards. - now, release the button. - press the button (A) within 5 seconds of the previous action and keep it pressed: the glass panel will complete a full opening and closing cycle. - only release the button at the end of this cycle. |