Refitting

1. Using a plastic blade, lift up the rear end (1a) of the moulding, releasing it from the adhesive strip (1b).

2. Completely remove the moulding (2a) releasing the adhesive strip (1b) along the entire moulding.

Removing

- Check that the new moulding is not damaged.

1. Clean any residues of adhesive and degrease the entire seat (1a) in the body where the moulding adhesive strip will be stuck using heptane.

Stick the moulding to the body at an ambient temperature that is not too low.

- Place the moulding in position starting from the front end, then gradually remove the protective film for the adhesive strip and, at the same time, stick the actual adhesive strip to the body.

- Press again, gradually along the entire moulding to improve the adhesion of the adhesive strip to the body.