Removing
(
Refitting
)
 | If the tyre pressure sender is replaced, the following procedure must be carried out in sequence using the diagnosis equipment: - Aerial replacement. |
|
|
Removing
(
Refitting
)
|
|
|
- Position the vehicle on a lift and raise it. - Remove the number plate lights. |
|
|
  |
1. Working at the back of the additional wheel arch, disconnect the electrical connection (1a) for the pressure sender (1b).
2. Remove the rivets using a drill. 3. Keep the pressure sender and bracket. |
  |
1. If necessary, remove the rivets (1a) using a drill and separate the pressure sender (1b) from the bracket. |
|
|
Refitting
(
Removing
)
- Check that the pressure sender is not damaged. - If removed, place the pressure sender on the bracket and fit the rivets. - Position the pressure sender and bracket. - Fit the rivets. - Connect the electrical connection. |
|
|
- Remove the car from the lift. - Check that the TPMS is working properly. |