Removing
(
Refitting
)
 | If the tyre pressure sender is replaced, the following procedure must be carried out in sequence using the diagnosis equipment: - Aerial replacement. |
|
|
Removing
(
Refitting
)
|
|
|
- Position the vehicle on a lift and raise it. |
|
- Or, alternatively. |
|
|
- Or, alternatively. |
|
  |
1. Working in the wheel arch, remove the protection (1a) for the electrical connection for the sender (1b). |
  |
1. Disconnect the electrical connection for the sender unit.
2. Remove the rivets using a drill. 3. Remove the pressure sender. |
|
|
Refitting
(
Removing
)
- Check that the pressure sender is not damaged. - Position the pressure sender. - Fit the rivets. - Connect the electrical connection for the sender. - Fit the protection to the electrical connection for the sender. |
|
|
|
|
- Remove the car from the lift. - Check that the TPMS is working properly. |