1. Remove the brake/clutch fluid reservoir cap and connect suitable equipment to the reservoir.

To prevent impurities entering the brake-clutch fluid reservoir, before undoing the cap clean it and the entire upper surface of the reservoir next to the filler thoroughly.

1. Remove the protective plug and connect the recovery device (pipe and reservoir) to the bleed valve on the clutch control coaxial actuator connector.

2. Open the bleed tap.

- Open the equipment reservoir tap slowly.

- Wait for all the air in the clutch release hydraulic system to escape completely.

- Close the bleed tap, remove the recovery device (pipe and reservoir) and fit the protective plug.

- Remove the brake-clutch bleed equipment.

- Check that the clutch disengages and that the gears engage properly.

- Check the fluid level in the brake-clutch reservoir is correct.