Contents

To apply this procedure, the following must be borne in mind:

1 - Measurements cannot be taken on the Air Bag wiring

2 - System fault diagnosis should be started leaving the vehicle loads connected

3 - The fault should be 'Present' or 'Present Intermittently' and not 'Intermittent'. If the fault is Intermittent then the procedure is not applicable; proceed with an accurate check on the line where the fault was signalled

4 - Not all the simulation sensors are available (e.g. side impact sensors).

The airbag fault warning light is controlled by a dedicated connection to the airbag control unit Instrument Panel Node.

The Air Bag wiring is a safety component. If there are problems with the cables or the connectors then the wiring should be replaced in its entirety.

		Test results
1	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Turn the ignition key to the STOP position. Check that the connector is correctly connected to the control unit and there are no faulty connections in the intermediate joint	Go to Step 2	One or more connectors are not correctly connected	Reconnect the connector correctly.
2	ELECTRICAL CIRCUIT CHECK	All OK	Problems encountered	Operation
	Check the electrical circuit	Go to Step 3	S.C. resistance too low O.C. resistance too high	Restore correct operation Restore correct operation
3	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Check the electrical circuit for short circuits to Vbatt. and earth.	Go to Step 4	Short circuit to Vbatt. Short circuit to earth	1. Restore insulation to + battery 2. Restore insulation to earth
4	WINDOW BAG CHECK	All OK	Problems encountered	Operation
	Turn the ignition key to the STOP position. Disconnect the faulty window bag from the wiring and connect the dummy resistance in its place. Turn the ignition key to MAR and activate communication with the diagnostic equipment. Check whether the fault in the window bag has become intermittent	Go to Step 5	The fault is still Present	Turn the ignition key to the STOP position. Replace the rear wiring Op. 5505C40 INTEGRATED PASSENGER COMPARTMENT WIRING - R.R. WITH INTERFERING COMPONENTS REMOVED
5	REPLACING THE WINDOW BAG	All OK	Problems encountered	Operation
	Turn the ignition key to the STOP position. Replace the faulty window bag Op. 5580C50 WINDOW BAG MODULE (ONE) LH OR RH - R.R Delete the errors using the diagnostic equipment	End of diagnosis