The diagnostic equipment signals the following error: "C1211 - Control Unit Broken"
|
This error is signalled if the control unit detects an internal error during its continuous check of the internal components. |
|
Test results |
||||
|
1 |
ABS CONTROL UNIT REPLACEMENT |
All OK |
Problems encountered |
Operation |
|
Replace the ABS electrohydraulic control unit Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R. |
Go to Step 2 |
|||
|
2 |
CORRECT OPERATION CHECK |
All OK |
Problems encountered |
Operation |
|
Delete the errors using the diagnostic equipment. Turn the key OFF and then ON to ensure that the control unit checks whether the errors are still present. Check that the fault is no longer present |
End of diagnosis |
|||